Rubber seal for handle on boot lid / van door of all Australian Minis. Model: Mini
Rubber seal for handle on boot lid of late model Rover Minis. Does not suit Australian Minis, only later imported Minis.
Gasket set to suit boot hinges on Mini. Original hard style - genuine MG Rover part. Kit does 2 hinges.
Cross reference: CM403
Rubber gasket set to suit boot hinges on Mini. Kit does 2 hinges. Cross reference: CM404
Chrome boot hinge set to suit all Mini sedans. Includes two hinges and mounting screw set. Model: Mini
New boot lid handle to suit all Australian model Mini sedans and vans (1961 to 1978). Shaft will require cutting to length on sedan models, as it is longer on a Van (this handle fits both). Model: Mini
Mini boot seal - fits to boot lid. Suits all Mini sedans. Quality new soft version. Can be glued or use clips - part 14A6585.
When fitting the thinner part should butt up to the body, not the fatter part. Otherwise the boot will be very difficult to...
Clip for Mini boot seal (14A6584). Require 26 clips per car.
Mini boot lid support cable. Suits all Mini sedans. Require 2 per vehicle. Best to replace as a pair as the old ones could be stretched.
14A6740 / HYA2286
Rubber buffer for Boot Board as fitted to Mini Cooper S. Model: Mini
Rubber Bump Stop for number plate flap on boot lid of all Mini models. Require 2 per vehicle.
One pair (2) of Rubber Bump Stops for number plate flap on boot lid of all Mini models.
High density foam seal for fuel tank filler neck to body, inside boot. Suits all model Mini including Van, Austin Healey Sprite and MG Midget.
Model: Mini / Sprite & Midget
Rubber grommet to seal fuel tank filler neck to body. Suits all model Minis including Mini van and also some Mini Moke with small neck side fuel tank. Model: Mini / Moke
Rubber Grommet for Battery Box floor (fits 3/4" hole). Approximate diameter is 23mm. Cross reference: BH021
Rubber grommet/plug for floor/boot floor in Minis. Fits hole 3/8" diameter.
Screw for attaching number plate flap to boot lid. Six required per car (3 per hinge). Model: Mini
Chrome metal number plate illumination lamp. Complete unit with globes. Cross reference: BHA4153
Plastic number plate illumination lamp. Black in colour. Complete unit with globes and base.
Budget Plastic number plate illumination lamp. Chrome colour. Complete unit with globe.
Vehicle: Mini / Morris Minor / Sprite & Midget
Multiple use 1/4" UNF nut. Use for:- Boot Lid hinge- Door check strap to door- Accelerator Cable Pin (ACC5062)- Heater Tap Stud (53K402)
Self tapper screw to attach the boot catch to the boot lid (on the top edge). Require two screws. For spring washer see part WL700101.
Small spring washer - multiple use: - Use with self tapper screw (GHF425) to attach boot catch at top edge of boot - Use under window winder and door handle screw. Cross reference: LWZ203